VLS Service Manual - REV2015.04
Accessories
Page | 81
4. Remove the tailstock cover by turning over the tailstock and locating the four screws holding it in place.
Remove these screws and set the cover and screws aside.
5. Remove the four screws and washers securing the toggle clamp.
6. Install new toggle clamp with the four screws and washers.
Rotary Clamp
NOTE:
If you are using an extended rotary you will not have the tailstock cover in step 4. All other steps are the
same.
1. Remove the Rotary fixture from the system if installed and place on a flat working surface.
2. Locate and remove the serial tag plate by removing the two screws holding it in position. Set aside.
3. Slide the tailstock out of the rotary base plate.
Summary of Contents for VLS Series
Page 1: ...VLS Service Manual...
