Installation Manual of Network Camera
72
Micro SD Card
Figure 3-108
Install the SD Card
Press RESET about 10s when the camera is powering on or rebooting to restore the default
settings, including the user name, password, IP address, port No., etc.
A wireless router with the WPS function is required to enable the WPS function of the camera.
Refer to the steps below.
1)
Press the WPS button on the router.
2)
Press the WPS button (about 2s) on the camera within 120s you enable the WPS of the
router to join in the wireless network.
The WPS button works as a reset button only when you press it when the camera is powering
on.
Press the WPS button on the camera, and then press the WPS button on the router will work
as well, and the expire time of WPS connection on the camera is 120s.
The link indicator blinks if the wireless connection succeeded.
3.9.3
Installation
Before you start:
Make sure the device in the package is in good condition and all the assembly parts are included.
Make sure all the related equipment is power-off during the installation.
Check the specification of the products for the installation environment.
Make sure the power supply is matched with your required voltage to avoid damage.
