UHP SCPC MODEM
USER MANUAL, v3.2
© ROMANTIS 2015
11
www.uhp.net
2.
CONFIGURATION
A computer used for configuration of UHP router should be configured for the same network as the router. By
default the router has 10.0.0.1XX IP-address (where XX are the last two digits of the router’s serial number) with
255.255.255.0 subnet mask. When connecting to the router the computer should be assigned an IP-address within
10.0.0.1 to 10.0.0.254 range with the exception of the router’s own IP-address.
The router can be accessed by typing its IP address 10.0.0.1XX in the web browser of the computer. If the
connection is correct a WEB-page of UHP router will be displayed.
2.1
Configuring IP Address
When connection between the router and computer is established the initial UHP IP-address should be reassigned
according to the required configuration. When connected to the WEB-interface follow these steps:
Go to a tab of Menu of commands: Advanced –> IP routing;
Choose Add IP Address in the Management and control panel;
Enter the following fields and click Apply.
Figure 4 Assigning new IP address
After a new IP-address is assigned the routing table will appear as shown below (see Figure 5).
Figure 5 UHP routing table
To delete an unusable IP address choose the corresponding entry in the routing table and click Delete in the form
that will appear.
P
LEASE CLICK
S
AVE
C
ONFIG TO SAVE THE CHANGES IN THE
C
ONTROL AND STATISTICS TREE
Similar IP configuration is required for the Station-2.
