All contents current at time of publication.
10AF
–
V1.0
–
03/15/2021
User Manual
–
CX6936/CX8936
FSMBLE
C
Find a suitable position in range of locking
unit. Make sure that the surface is smooth,
dry and robust. Do not position several units
very closely to make sure their radio does
not interfere.
Mark drilling positions through mounting
holes and drill holes if necessary.
Use suitable flat headed screws and screw
ancors if necessary (both not included).
If you want to attach the cable from a side,
use large enough rubber or plactic spacers
to make sure the cable is not squeezed.
1
2
Installation
A
B
3
Attach device to surface.
Attach cable to pins as required in your specific project. The two connectors and
for pin 1-8 and 9-16 are both removable. See table below for the correct pin assignment.
Power supply: 5-24 V DC | Relay connections: DC: max. 48V/0.7A - AC: max. 32V/0.5A
To pair the device with a locking unit, the assigned locking unit needs to be
in service mode. Usually the locking unit enters service mode if an
authorized service key is presented to the unit.
Use a screwdriver or a similar tool to set the rotary switch
to the position 8 then shortly press the button
to change to pairing mode.
Press button again to pair the device with a locking unit.
Close the device with the lid by attaching the 4 included screws.
7
6
Position:
Function:
0
Default position. Press button
short to couple in paired
locking unit.
4
Press button short to enter
service-mode
8
Press button short pairing for
pairing mode. Press augain
for pairing unpairing with a
locking unit.
1
4
5
9
