uhlmann & zacher CX6172, Operating And Assembly Manual

Page: 34 / 46

CX6172/4 T
ABLE OF CONTENTS
34
5 Commissioning
5.1 Managing the locking system
The locking system can be managed using the Keyvi management software.
Before a locking system can be used, it has to be personalized and the settings
have to be customized.
5.1.1 Customisation
Every door and key in the electronic locking system Clex prime should be known
to the management software for the respective locking system for subsequent
programming. This procedure is called customisation.
During customisation, the door or the door handle installed inside is assigned a
Door ID (D-ID) and the key is assigned a Key ID
(K-ID) by the management software Keyvi.
5.1.2 Changing the settings
The following settings can be changed:

Authorisations (see chapter 3.1.1Authorisations, page 7)
 Time zones (see chapter 3.1.2Time zones, page 8)

Time
 Engagement time (defines the time for which the door handle remains
engaged after holding up an authorised key, see chapter6.2Opening the
door, Page 35)

Wake-up sensitivity (see chapter 6.1Automatic wake up, page 35)

Expiry date of a key (see chapter 3.1.3Automatic expiry date, page 8)
 Radio response of the door handle (wake-on-radio mode)
The settings have to be changed first in the Keyvi management software for the
individual door handles or groups of door handles. The software consolidates
these settings into tasks, which then need to be transferred first to the service unit
or to ClexTouch. From there, they can be transferred to the individual door
handles.
If the door handle is located in a Keyvi radio network, then the transfer can also
be done via radio.
For additional information refer to the documentation on CX6530 Keyvi
management software, on the CX6510 service device, CX6522 ClexTouch and
CX6520 programming station.
5.2 Configuring the door handle
Precondition: Orders have been created in the Keyvi management software and
sent to the service device or to ClexTouch.

Hold the service key in front of the reading unit of the door handle to switch
the door handle to the service mode.

Using the service unit or ClexTouch, send the respective job to the door
handle (see operating manual of CX6510 service unit or that of CX6522
ClexTouch)