uhlmann & zacher CX6162, Operating And Assembly Manual

Page: 17 / 27

CX6162/66 C
OMMISSIONING
16
5.2 Managing the locking system
The locking system can be managed using the Keyvi management software.
Before a locking system component can be used, it has to be personalized and
the settings have to be customized.
5.2.1 Personalization
Every door and key in the electronic locking system Clex prime should be known
to the management software for the respective locking system for subsequent
programming. This procedure is called customisation.
During customisation, the door or the knob cylinder installed inside is assigned a
Door ID (D-ID) and the key is assigned a Key ID (K-ID) by the management
software Keyvi.
5.2.2 Changing the settings
The following settings can be changed:

Authorisations (see chapter 3.1.1 Authorisations, page 5)

Time zones (see chapter 3.1.2 Time zones, page 6)
 Time
Engagement time (defines the time for which the knob cylinder remains engaged
after holding up an authorised key, see chapter6.2 Opening and locking the
door., Page 18)

Wake-up sensitivity (see chapter 6.1 Automatic wake up, page 17)
 Expiry date of a key (see chapter 3.1.3 Automatic expiry date, page 6)

Radio response of the knob cylinder (wake-on-radio mode)
The authorisations have to be changed first in the Keyvi management software for
the individual knob cylinders or groups of knob cylinders. The software
consolidates these settings into tasks, which then need to be transferred first to the
service unit or to ClexTouch. From there, they can be sent to the individual knob
cylinders.
If the knob cylinder is located in a Keyvi radio network, then the transfer can also
be done via radio.
For additional information refer to the documentation on CX6530 Keyvi
management software, CX6510 service device, and CX6522 ClexTouch.
5.3 Configuring the knob cylinder
Precondition: Orders have been created in the Keyvi management software and
sent to the service device or to ClexTouch.

Hold the service key in front of the knob cylinder to switch the knob cylinder
to the service mode.

Using the service device or ClexTouch, send the respective order to the knob
cylinder (see operating manual of CX6510 service device or that of CX6522
ClexTouch)