1
Gantry Crane 1:87
Description
This gantry crane was built in large numbers and can still be found at many load tracks today.
This finished model is constructed very finely in detailed plastic. Quiet miniature motors with metal
transmissions lift and lower the crane hook and move the trolley. The crane has two adjustable
outputs e.g. for lighting, lifting magnet or grip arm.
The model is equipped with a digital decoder, so that all functions can be controlled with either a DCC
or Märklin Motorola Digital Center. Using the key connections, analog operation is also possible.
Packing contents
x
Gantry crane fully assembled
x
Roof with two bearers for optional mounting
x
Instructions
x
Adhesive label
Unpacking
Remove the upper foam material and then
the lower foam material block from the
packing. Hold the gantry crane by the base
plate and carefully remove the middle
foam block from the packing. The middle
foam block consists of two sections
between which the crane hook is located.
Tip: In order to avoid damage we
recommend that you only transport the
gantry crane in this packing.
Roof assembly
If desired glue the enclosed bearers to the
intended location under the roof.
The roof should either be placed or only
loosely fixed so that the trolley remains
accessible in the case of service.
Note: During installation or in the case of
transport the crane hook must be raised
completely so that the rope cannot jump
off the pulleys.
