uher SG 631 Logic, Operating Instructions Manual

Page: 10 / 32

1.7 Record Operation for Users in a Hurry
As the quality of the recording is essentially dependent upon the correct
setting of the record level, this step should be given particular attention:
1. Make certain that the input source to be used in recording is
connected and switched on.
2. Press POWER switch (Check connection to mains power outlet).
Function indicator above STOP key must light up.
3. Load tape and wind past switching foil onto take-up spool (see
and 3.15).
4. Set a) tape type switch for tape used (see sec. 3.21),
b) reel size switch (see sec. 3.24),
c) mode selector switch (8) to desired record mode (see sec. 3.6)
and
d) tape speed selector
(see sec.
5. Touching them lightly, one after another, actuate the RECORD®,
PAUSE and START keys. The function indicators above the
keys will light up.
6. Press the zero reset button of the counter to mark the beginning
of the recording.
7. Using the master control (5) , fade in the desired input sources
(see sec. 3.3).
8. Using level controls © to © , set maximal record level for loudest
passages to be recorded (see 3.1 and 3.2).
9. Press LIMITER switch and check setting for correct (maximal)
record level (see sec. 3.5).
10. Tip PAUSE k e y © once more. Tape transport and recording will
begin. Tipping the PAUSE key still again will interrupt tape motion
and recording.
Connect stereo headphones (see sec. 2.2) and adjust their volume,
using headphone volume control @ . Check recording acoustically
(as described in sec. 3.7) by pressing the MONITOR switch (9)
Lightly tipping the STOP key ends record operation.
To switch the recorder off, press the POWER switch .
34