UGREEN cm198, User Manual

Page: 5 / 33

5
Offline copy
1. Install disk A and B into this docking station, connect to power source, and turn
the docking station on.
2. Long press the copy button for three seconds and release, and then click the
copy button to start offline copy.
3. Four indicators will be on when finishing copy process and the buzzer will ring
„beep“ sound three times.
4. When finishing offline copy, right click „Computer“, choose „Computer
management“, open „Disk management“, right click on offline disk, and choose
„Online“ to reconnect the disk to your co
mputer.
Note
1. Offline copy may cause additional issues, thus you should use this function with
caution. Remember backup hard drive data in advance before offline copy.
2. Under offline copy mode, you can only copy from disk A (source disk) to disk B
(target disk) and the capacity of disk A must be less than disk B.
3. Offline copy will format disk B. After copying, the capacity and partition of disk B
will be consistent with disk A. If you need to restore the capacity of disk B, you
need to repartition disk B.
How to take out
1. Safely remove hardware on your computer.
2. Press the power button to turn it off.
3. Disconnect the USB cable and power adapter.
4. Take out your hard drives.
Note : Always use the Safely remove hardware feature before disconnecting your hard
drive.
Safety notes
1. Works with USB 12V +/- 5% power supply and exceeding the standard voltage
range may cause damage to the product or cause potential safety problems.
2. Do NOT disconnect the hard drive docking station the hard drive during data
trasferring in case of files missing or the disk damage.
3. Keep out of reach of children, in case of potential safety problems by accidentaly
touching the power plug.
4. Falling down, squeezing, impacting, and throwing may damage the product.