Instruction for use (rev 141119)
e.ON 200 NEO / e.ON 250 NEO
UGIN DENTAIRE
28
5.7.
SAVING & PROGRAMMES’ TRACEABILITY
This unit is equipped with a USB 2 socket for data backup and transfer.
SAVING THE PARAMETERS (FURNACE / USB)
1)
Insert the USB stick into the right side of the unit
2)
Wait until it is recognized and the logo
appears
3)
Access the 5-lines menu by press the key
4)
Select the function “Copy Prog (Furnace
USB)”
5)
Wait until the data transfer is completed
For more information on this data backup, see chapter 5.2 - CONFIGURATION
TRACEABILITY OF CYCLES
The same procedure as described above applies.
All full performed cycles are saved on the CPU-card of the furnace.
The saved files in .PDF format allow to view and print all parameters.
Each cycle is saved on a separate page, to avoid any risk of confusion.
For more information on this data backup, see chapter 5.2 - CONFIGURATION
5.8.
PERIPHERALS
The USB 2 port allows the connection of a multiport data hub (not supplied).
This function may be useful when using a mouse (with or without wire) and a USB stick at the same time.
ATTENTION: with the hub, the furnace can detect only one USB stick at a time
Summary of Contents for e.ON 200 NEO
Page 2: ......
