UFREE SPORTS VEHICLE
www.scooter-manufacturer.com
6
ADJUSTING THE BRAKES
Fig. 4
Fine brake adjusting: Fine
brake adjustment can be
carried out on both ends of
brake bowden wire by means
of the screw 1 and nut 2.
Basic brake adjusting:
It is carried out in such a way,
at first, the nut 2 will be
loosened and the screw 1 of
fine tuning screwed-in.
Loosen the locking nut 3 and
tighten the adjusting screw 4
so that the wheel can be free
turned. Tighten the locking
nut 3.
Don't release the wire catcher 5!
FRONT BRAKE PADS REPLACEMENT: FIG.7
At first, loosen the nut 920.006.01 of fine front brake adjustment. Screw-in fully the
screw. Unscrew maximum the adjusting screw and lock it by fine tightening the nut
920.001.01. Dismantle the front wheel. Unscrew the nuts 920.008.01 on the front
brake and remove the screws 911.001.01. Unscrew two screws 914.009.01 from the
side of control lever on brake body and separate both bodies 512.011.00 each other.
Remove the old brake pads from both parts. Slide the brake plate, fitted with pin, into
the part with operating mechanism. Force on carefully the brake plate into the opposite
piece. Before reassembly clean the whole brake. Assembly follows in reverse sequence.
REAR BRAKE PADS REPLACEMENT: FIG.7
Before replacing the rear brake lining it is necessary to loosen the nut 920.006.01 of
fine adjustment of rear brake. Screw-in fully the screw of fine adjustment. Loosen the
nut 920.001.01 of basic adjustment. Unscrew maximum the adjustment screw
112.030.00 and lock it by fine tightening the nut 920.001.01. Don't release the wire
catcher 512.016.00 and dismantle the rear wheel. Shift the whole brake out of the
guide pins. Unscrew both screws 912.003.01 from the control lever side. Separate both
bodies 112.003.00 each other and shift the worn-out brake plates out of guide pins
clean carefully the brake and put the new brake plates on the guide pins so that they face
by lining towards themselves. The assembly follows in a reverse way. After mounting
the rear wheel carry out the chain adjustment and basic brake adjustment.
