SYMPTOM
PROBLEM
SOLUTIONS
Air leak near top of tool or
1.
O-ring in trigger valve is damaged.
1.
Check and replace O-ring.
in trigger area
2. Trigger valve head is damaged.
2.
Check and replace.
3.
Trigger valve stem, seal or O-ring
3.
Check and replace trigger valve
is damaged.
stem, seal or O-ring.
Air leak near bottom of
1.
Loose screws.
1. Tighten screws.
tool.
2.
Worn or damaged O-rings or
2.
Check and replace O-rings or
bumper.
bumper.
Air
leak
between
body
1.
Loose screws.
1. Tighten screw.
and cylinder cap.
2.
Worn or damaged O-rings or seals.
2.
Check and replace O-rings or
bumper.
Blade driving fastener too
1.
Worn bumper.
1.
Replace bumper.
deep.
2. Air pressure is too high.
2.
Adjust the air pressure.
3.
Need to adjust depth control.
3. Adjust depth control (flush drive
roller in front of trigger)
Tool does not operate well:
1.
Inadequate air supply.
1.
Verify adequate air supply.
can not drive fastener or
2.
Inadequate lubrication.
2.
Place 2 or 6 drops of oil into air inlet.
operates sluggishly.
3.
Worn or damaged O-rings or seals.
3.
Check and replace O-rings or seal.
4.
Exhaust port in cylinder head is
4.
Replace damaged internal parts.
blocked.
Tool skips fasteners.
1.
Worn bumper or damaged spring.
1.
Repalce bumper or pusher spring.
2.
Dirt in front plate.
2.
Clean drive channel on front plate.
3.
Dirt or damage prevents fasteners
3. Magazine needs to be cleaned.
from moving freely in magazine.
4.
Worn or dry O-ring on piston or
4.
O-ring needs to be replaced
lack of lubrication.
And lubricated.
5.
Cylinder covers seal leaking.
5.
Replace Sealing washer.
Tool jams.
1.
Incorrect or damaged fasteners.
1.
Change and use correct fastener.
2.
Damaged or worn driver guide.
2.
Check and replace the driver.
3.
Magazine or nose screw loose.
3. Tighten the magazine.
4.
Magazine is dirty.
4.
Clean the magazine.
Below is a picture and explanation of the lock out safety mechanism.
The Lock Out engages the safety and will not let the tool fire when the nails in the magazine
get down to 4 or 5 nails to keep the user from dry firing the tool and leave tracks from the driver on the deck.
For Application Questions call John at
888-377-0028
or 800-352-0028
PARTS LIST ON FOLLOWING PAGE:
