UFO MICATRONIC T23EN, User Manual

Page: 30 / 36

28
4.2 Thermostat Control Model - T19EN
Turn the button 0 to 1, to start the heater.
Adjust the thermostat button from low to high heating
levels for your preferred room temperature. Heater
will operate in low and high power cycles to keep the
ambient temperature at the desired level.
WARNING! Heater continuously operates at low power until it is switched to “0” position
manually. Thus, it prevents you from possible dangers such as covering the heater or
wrong positioning by warning you with the visible glowing of the heating element.
5. SAFETY FUNCTIONS
5.1. Tip Over Protection
5.2. Safety Distance Sensor (
For Only Remote Control Model T23EN)
UFO MICATRONIC, has “Tip Over Protection” system to prevent the risk of fire in case
of heater is tipped over. This function works differently in “Remote Control Model” and
“Thermostat Model”.
“Remote Control Model” warns with a three long “beep” signal and “Er” warning on
the screen, when it is tipped over more than 30° angle. After these audible and visual
warnings, it returns back to stand by mode “H0”. Press the On/Off button in order to
activate the heater again.
“Thermostat Control Model” switches off when tipped over more than 40° angle and
switches on when returned back to correct operation position.
CAUTION! This is an additional safety function. It does not prevent you against risks such
as injury and fire, by itself. Please read “Safety Precautions” section at the top of this
manual carefully.
UFO MICATRONIC is equipped with a sensor which detects the objects in front of the
command panel. This sensor reacts differently for 2 different case;