uebe Visomat double comfort, Instructions For Use Manual, Page: 30 / 91

C
EN-58 EN-59
C Operating the unit Operating the unit
english
english
7. Attaching the cuff
• Expose the upper arm.
• Push the cuff onto the upper arm until the
lower edge of the cuff is 2-3 cm above the
crook of the arm (Fig. 1, Fig. 2).
• When using the unit on the left arm, the air
hose runs to the unit through the middle of
the crook of the arm so that the 4 cm long ar-
tery marking is automatically located centrally
above the pulse position (Fig. 3).
• When using the unit on the right arm, the cuff
must be rotated to the left until the artery
marking is on the pulse position. The air hose
then runs along the inside of the upper arm
(Fig. 4).
Manual setting of date and time
With the unit switched off, briefly press a Start/Stop button
and immediately afterwards, while the full display test is still
in progress, press the MEM memory recall button for at least
2 seconds until the year in the display starts to flash (Fig. 1).
Set the year using the two Start/Stop buttons (button 1 =
one number up, button 2 = one number down). Press the
MEM button to memorise the input for the year and proceed
to setting the month (Fig. 2).
Use the two Start/Stop buttons to set the month and confirm
your input using the MEM button. Follow the same procedure
for setting the day, the hours and the minutes (Fig. 3).
Fig. 1
Fig. 2
Fig. 3
Fig. 1
Fig. 2
Fig. 5
Fig. 3
Fig. 4
– Now pull the free cuff end tight and close
the Velcro fastener (Fig. 5)
• Please fit the cuff so that the microphone
rests on the skin. Tip:
– Bend your arm slightly.
– The upper arm muscle is tensioned slightly.
– This slightly increases the circumference
of the arm.
• Check if the measurement arrow on the cuff
is inside the “marking for arm circumference“
at the edge of the cuff.