background image

22

23

Exploded View

17

8

16

15

14

13

12

11

10

9

7

5

1

4

3

2

6

No.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

Name

Propeller Guard

Propeller A

Upper Cover

Propeller B

Board for Front LED (White)

Board for Rear LED (Green)

Motor Part for Propeller B (CW)

Motor Part for Propeller A (CCW)

Receiving Board

Eyes LED Light Board

Barometer

Lower Cover

Motor Holder

Lampshade

Landing Gear

Camera Gimbal

Drone Barttery

No.

Name

Troubleshooting Guide

The

transmitter

indicator

light is off

Fail to

pair the

drone with

transmitter

The drone

is under-

powered

or can not

fly.

The drone

can not

hover and

tilts to one

side

The drone

indicator

light is off

Can not

see the

picture

1

2

3

4

5

6

Problem

Problem Cause

Solution

No.

1. The transmitter battery is too low.

1. Replace battery.

2. The battery positive pole and negative

    pole are in reverse order.

2. Install the battery in accordance with the

    user manual.

3. Poor Contact.

3. Clean the dirt between the battery and the

    battery alice.

1. Indicator light is off.

1. The same as above 1.2.3.

2. There is interfering signal nearby.

2. Restart the drone and power on the

    transmitter.

3. Misoperation.

3. Operate the drone step by step in

    accordance with the user manual.

4. The electronic component is damaged

    for frequent crash.

4. To buy spare parts from local seller and

    replace damaged parts.

1. The Propeller deformed seriously.

1. Replace Propeller.

2. The drone battery is too low. 

2. Recharge the drone battery.

3. Incorrect installation of Propeller.

3. Install the Propeller in accordance with

    the user manual instruction.

1. The Propeller deformed seriously.

1. Replace Propeller.

4. Flash slowly 3 times and then off.

4. The barometer is broken.

2. The motor holder deformed and out of

    verticality.

2. Replace the motor holder.

3. The gyro did not reset after violent crash.

3. Put the drone on the flat ground for

    about 10s or restart the  drone to

    calibrate again.

4. The motor is damaged.

4. Replace motor.

1. The drone battery is too low.

1. Recharge the drone battery.

2. The battery is expired or overdischarge

    protection.

2. Buy a new battery from local seller to

    replace or recharge the battery.

3. Poor contact.

3. Disconnect the battery and then connect

    it with the plug again.

1. Did not connect the wire of camera box

    or poor contact.

1. Check the wire and connect well.

2. There is interfering signal nearby.

2. Cut off the wire and re-connect.

3. Damaged camera.

3. Buy a new camera box from local seller

    to replace.

Summary of Contents for U842-2













Reviews: