9
Figure 6. Horizontal sensitivity setting
3.5.
Cursor Function
To perform measurement on the observed signal, 'Cursor' menu is used. 'Cursor' menu could be activated
by selecting the button which is seen as (22) in the Figure 3b (Menu 2). To switch to Menu 2, the buttons
providing switching among the menus are used (in the Figure 3a, (10) and (19) buttons).
There are 4 cursors total which consists of 2 pcs (t1 and t2) for measuring time, 2 pcs (V1 and V2) for
voltage. To changeover the cursors, sweep them by holding down with touch-pen. In case the cursor is
activated, it gets highlight. The measured values are shown in the second line of the area numbered (1) as
time (delta T), voltage (delta V) and the frequency depending on time.
Figure 7. Cursor function
