UBSAN Q4 FPV, Instruction Manual

Page: 15 / 22

● Do not mix old and new batteries ● Do not mix different types of batteries
● Do not charge non-rechargeable battery.
8.2 INSTALL THE TX BATTERY
Close the cover
Remove the cover
Install 4 x AA batteries
according to the correct polarities
PUSH PUSH
1. When the power on the transmitter runs low, the red LED will blink quickly and the
LCD screen will turn black, also the transmitter and X4 may disconnect. Please replace
with new batteries.
2. If the batteries in the transmitter runs low while flying the X4, you can still control the
X4, please land the X4 and then replace batteries.
3. The Transmitter can only use 2S Lipo batteries, 4XAA batteries or NI-MH AA
batteries, other batteries will damage the Transmitter.
Notice
：
15
©
2015 Hubsan
哈博森科技 版权所有
8.3 VIDEO REPLAY SETUP
If you would like to replay the previous videos on transmitter, then follow the instructions
below.
Pull the throttle stick to the lowest position and long press the Pitch stick simultaneously to
enter into MAIN MENU interface. Push the Elevator stick up/down to select “Play Record”.
Select “Exit” to exit.