2. QUAD COPTER MOTOR LED INDICATOR
3. QUAD COPTER BATTERY
Indicator Status:
Front LED is blue; Back LED is red.
1.Power on: 4 LED indicators blink simultaneously
2.Compass Calibration:
1
）
Horizontal calibration: 4 LED indicators blink circularly.
2
）
Vertical calibration: 4 LED indicators blink alternately.
3.Quadcopter Calibration
：
4 LED indicators blink slowly.
4.GPS Flight: 4 LED indicators remain lighted.
5.GPS Return : 2 front LED remain lighted, and 2 back LED blink slowly.
6.Low Voltage: 2 front LED remain lighted, and 2 back LED blink quickly.
7.Disconnection: When the quad is out of control, 2 front LED indicators blink
alternately, and 2 back LED indicators remain lighted.
3.1 INTRODUCTION
The quad copter battery is a rechargeable Li-Po battery with 550mAh capacity and
7.6V .
The battery should only be charged with the HUBSAN charger to avoid
overcharge.
3.2 INSTALL THE BATTERY
Push the battery into the battery
compartment correctly.
3.3 CHARGING
Connect the battery to the USB charger, then connect the USB charger to USB
devices, such as a computer or mobile power charger (5V
，
1A).
The USB LED indicator blinks in red when charging, and remain lighted after the
battery is fully charged, then please unplug the charger and battery
Charging time: around 200 mins.
Please make sure the battery is fully charged before the first use.
Please fully charge the batteries to avoid loss of control due to low voltage.
5
4 PROPELLER
4.1 Introduction
The quad is equipped with 5.3" propellers that are marked with A and B.
Propellers are consumable, please replace them with new ones if there is any
damage.
