ZED-F9K - Integration manual
When insufficient information is available for the receiver to perform any of these time-base
conversions precisely, pre-defined default offsets are used. Consequently plausible times are nearly
always generated, but they may be wrong by a few seconds (especially shortly after receiver start).
Depending on the configuration of the receiver, such "invalid" times may well be output, but with
flags indicating their state (e.g. the "valid" flags in UBX-NAV-PVT).
u-blox receivers employ multiple GNSS system times and/or receiver local times (in order
to support multiple GNSS systems concurrently), so users should not use UBX messages
reporting GNSS system time or receiver local time. It is recommended to use messages that
report UTC time and other messages are retained only for backwards compatibility reasons.
3.9.3 iTOW timestamps
All the main UBX-NAV messages (and some other messages) contain an iTOW field which indicates
the GPS time at which the navigation epoch occurred. Messages with the same iTOW value can be
assumed to have come from the same navigation solution.
enabled, iTOW can be used as an epoch collector only for
messages of the same group (e.g. priority navigation messages with the same iTOW value
can be assumed to have come from the same navigation solution).
Note that iTOW values may not be valid (i.e. they may have been generated with insufficient
conversion data) and therefore it is not recommended to use the iTOW field for any other purpose.
The original designers of GPS chose to express time/date as an integer week number
(starting with the first full week in January 1980) and a time of week (often abbreviated
to TOW) expressed in seconds. Manipulating time/date in this form is far easier for digital
systems than the more conventional year/month/day, hour/minute/second representation.
Consequently, most GNSS receivers use this representation internally, only converting to a
more conventional form at external interfaces. The iTOW field is the most obvious externally
visible consequence of this internal representation.
If reliable absolute time information is required, users are recommended to use the UBX-NAV-PVT
navigation solution message which also contains additional fields that indicate the validity (and
accuracy in UBX-NAV-PVT) of the calculated times (see also the
further messages containing time information).
3.9.4 GNSS times
Each GNSS has its own time reference for which detailed and reliable information is provided in the
messages listed in the table below.
Time reference
Message
GPS time
UBX-NAV-TIMEGPS
BeiDou time
UBX-NAV-TIMEBDS
GLONASS time
UBX-NAV-TIMEGLO
Galileo time
UBX-NAV-TIMEGAL
UTC time
UBX-NAV-TIMEUTC
Table 19: GNSS times
3.9.5 Time validity
Information about the validity of the time solution is given in the following form:
• Time validity: Information about time validity is provided in the
valid
flags (e.g.
validDate
and
validTime
flags in the UBX-NAV-PVT message). If these flags are set, the time is known
UBX-20046189 - R01
3 Receiver functionality
Page 54 of 105
C1-Public
Early production information
