Ublox XPLR-HPG-2, User Manual

Page: 22 / 28

UBX-22039292 - R01 Module configuration Page 22 of 28
C1-Public
Figure 19: ZED-F9R status LED locations
To disable the LEDs for reduced power consumption, cut the JP4-6 solder jumpers located on the
bottom side of XPLR-HPG-2, as shown in
Figure 20 .
Figure 20: Disable ZED-F9R status LEDs
ZED-F9R USB is connected to the 4-port USB hub IC and is available for connection through the J1
USB connector.
4.3 NEO-D9S L-band receiver
NEO-D9S is an L-BAND correction data receiver module. It provides global and easy access to satellite
L-band GNSS correction data.
The module is powered from the 3.3 V linear regulator and connects to the host through the I2C bus
with address 0x43.
Several NEO-D9S pins are exposed on J10 pin header, as shown in
Table 4 and Figure 21 .
NEO-D9S pin no. Signal name Available at Notes
21 NEO_RX1 J10-6 UART1 RX
20 NEO_TX1 J10-7 UART1 TX
1 NEO_SAFEBOOT J10-8 SAFEBOOT pin
8 NEO_RESET J10-9 Reset pin, active Low
Table 4: NEO-D9S signal availability