XPLR-AOA-1 and XPLR-AOA-2 explorer kits - User guide
UBX-21004616 - R10
XPLR-AOA anchor nodes and tags
Page 16 of 27
C1 - Public
Figure 12: Updating the software on the C211 board using s-center
4.3.4
Configuring the board
When connecting to the USB port on the C211, a serial port (COM port on Windows) is available on
the host. Connect the COM port to a terminal emulator or use the s-center tool
the port settings:
•
115200 kbps
•
8 data bits, no parity, 1 stop bit (8N1)
•
Flow control enabled using RTS/CTS
Having configured the COM port, configure the C211 using AT commands. The appropriate AT
commands for configuring direction finding through the C211 anchor nodes are described in the u-
connectLocate AT commands manual
☞
Although s-center does not support specific direction-finding AT commands using buttons, it is
possible to configure the COM port as a terminal for use with AT commands.
Due to the large amount of data received over the UART it may be advisable to increase the baud rate
over the UART interface. In the following command example, the baud rate is set to 1 Mbps using the
command
AT+UMRS
.
AT+UMRS=1000000,1
AT&W
AT+CPWROFF
