EVK-MAYA-W2 - User guide
UBX-22011269 - R04
Getting started
Page 8 of 20
C1 – Public
2
Getting started
This chapter describes the basic settings and procedures to get started with the MAYA-W2 EVK. All
referenced connectors, jumpers, and LEDs are shown in
☞
For more detailed information about the available connectors and configuration options, see
also
Figure 2: Evaluation board of EVK-MAYA-W261 overview showing main connectors
Follow the procedure below to evaluate MAYA-W2 series module using EVK-MAYA-W2:
1.
Connect the external antennas to EVK-MAYA-W271. Two external dual-band antennas for Wi-Fi
and Bluetooth communication are included in the EVK, which must be connected to the SMA
connectors (J10 and J11) on the evaluation board.
☞
EVK-MAYA-W276 is equipped with an internal PCB antenna and an optional SMA connector
for connecting an external antenna. For more information about the antenna connectors, see
also
2.
Connect the host interfaces to the host system. The EVB and supplied M.2 and SDIO adapters
use zero insertion force (ZIF) connectors and flat cables for connecting the adapters. To connect
the cables, gently flip up the small locking flap of the connector, align and insert the flat cable
with the blue marking pointing upwards, and then close the locking flap.
o
For SDIO connection through an SD card socket on the host system, connect the micro or full-
size SD card adapter with the flat cable to the SDIO connector (J3) on the EVB and insert the
adapter card into the host socket. The SDIO interface is used for Wi-Fi communication with
the MAYA-W2 series module.
SDIO/M.2 card ZIF
connector (J3)
D2/D3 LEDs
USB/UART
selection (J6)
M.2 card ZIF
connector (J2)
USB type-C
connector (J1)
SMA [ANT1]
connector(J11)
SMA [ANT0]
connector(J10)
SPI interface
connector (J13)
