C102-F9R - User guide
UBX-20029244 - R03
Page 14 of 32
C1-Public
Appendix
A.1
CAN termination
The CAN bus is terminated by including the jumper circled in Figure 2. The jumper is included by
default. If the termination needs to be removed, open the enclosure and remove the jumper.
Figure 2: Jumper (circled)
B
CAN configuration examples
This appendix contains example CAN configurations. Each example uses the following settings for
the CAN bus:
•
CAN bitrate: 500 kbps
•
CAN message ID: 0x123
•
DLC: 8
•
Cycle time: 0 ms
The example messages are compatible with firmware C100 v1.0.
B.1
Wheel tick configurations
B.1.1
Two rear-wheel ticks and direction
This configuration uses wheel ticks from two rear wheels and a separate direction signal. The
configuration entries are described in the tables below.
Startbit Length Byte order
Value type
Factor Offset
Min
Max
Unit
Source
40
16
big-endian
unsigned
1
0
0
65535
tick
RR
56
16
big-endian
unsigned
1
0
0
65535
tick
RL
8
2
big-endian
unsigned
1
0
0
3
direction
direction
Summary of Contents for C102-F9R
