PON
ONU
Battery Operating
Charging:
When you connect AC power and Battery at the same time, it is charged
automatically. In case of a new battery, you cannot make sure that the voltage value is
going up with your eyes because it is charged slowly.
Discharging:
When AC power stops, it is discharged automatically and the battery
replaces AC power.
Operating:
The battery normally operates for 6 hours in case of using every port. When
the battery starts charging via AC power again, it will be fully charged after 5 hours.
<Figure 10> Connecting AC power cable, DC power lines, and Grounding Cable.
Note The specification of power to be supplied to AC power supply of E3208E is
as follows.
-
Voltage : AC 100V ~ AC 240V
-
Power Consumption : max 16.9 Watt
-
Input Frequency : 50/60Hz
Warning Because the battery using to E3208E ONU is 12V (4.5AH) VRLA
battery, it may have the danger of gas-leak and of explosion on the
overcharge or the over-discharge.
E3208E cut off the current at less than 10.5V battery voltage and also
cut off the current at more than 13.5V battery voltage to charge.
(Charging current max 800mA)
The power supply that does not meet the above specifications can
cause damage to the product or a fire.
Connecting Console Terminal
E3208E can be configured or monitored by connecting a console port to the product directly.
The user can use the console cable that came with the product to connect the product and
the console terminal. Connect the RJ-45 connector of the console cable to the console port
of the product and the DB-9 connector (the other side of the cable) to the console terminal.
The terminal device used as the console terminal of E3208E should be set according to the
following communication configuration in order to communicate with E3208E normally.
Baud Rate: 9600 bps
Data Bit: 8 bit
Stop Bit: 1 bit
Parity Bit: None
Flow Control: None
E3208E Installation Guide
25
Summary of Contents for E3208E
Page 1: ...PON ONU E3208E Installation Guide...
Page 10: ......
