Ubiquiti UniFi USW-24-POE, Quick Start Manual

Page: 5 / 22

USP LED
USP Connect DC Input
Power Port
This button serves two functions for the UniFi Switch:
Restart Press and release the Reset button quickly.
Restore to Factory Default Settings Press and hold the Reset button for more than
five seconds.
The LED lights up blue when there is an active power connection on the USP DC
input.
This DC input provides redundant power when the UniFi Switch is connected to the
UniFi SmartPower Redundant Power System, model USP-RPS, via the USP Cable
(not included). If there is an AC power loss or internal power supply failure, the UniFi
Switch will draw power from the USP-RPS instead.
Connect the included Power Cord to the Power port.
Installation Requirements
Phillips screwdriver
Standard-sized, 19" wide rack with a minimum of 1U height available
For indoor applications, use Category 5 (or above) UTP cabling approved for indoor
use.
For outdoor applications, shielded Category 5 (or above) cabling should be used for
all wired Ethernet connections and should be grounded through the AC ground of the
power supply.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD