Hardware Installation
1. Pull out the sun visor and remove it. Then remove the
accessory port cover located on the bottom of the UVC-G3.
Accessory
Port Cover
Sun Visor
2. Hold the UVC-G3-LED with the Accessory Connector at
the bottom. Place the LED Ring over the front face of the
camera and insert the LED Ring until it locks into place.
Non-Protruding
Protruding
Note:
If the pre-installed screws protrude into the open
space of the LED Ring, use a phillips screwdriver to
turn each of the two screws counterclockwise until the
perimeter is clear. This will provide proper clearance and
allow the LED Ring to slide onto the UVC G3 camera.
