2
1. Install Feed to Dish
Install
B
Feed to
A
Dish by:
Q
M4 Bolt-Springlock-Washer Assembly (Qty. 4)
The Dish/Feed are keyed so that the feed can only be installed one way.
To install, line up the alignment pin on the Dish with the hole on the Feed
as shown in gure 1.
1
2. Install Main Mounting Bracket and Elevation Rod
Put
I
M10X150 Bolt on the
C
Main Mounting Bracket. Install
C
Main Mounting Bracket and
G
Elevation Rod to
A
Dish by:
J
M10X25 Bolt (Qty. 3)
O
M10 Washer (Qty. 3)
P
M10 Spring Lock Washer (Qty.
3)
N
M10 Nut (Qty. 3)
L
M16 Washer (Qty. 2)
M
M16 Spring Lock Washer (Qty. 1)
K
M16 Nut (Qty. 2)
Pivot Points should be loose to allow mounting frame to move so that
elevation rod can be installed.
3. Install Rocket and Waterproof Cables
Model MD-5G30 and MD-3G26 go to step 4.
Install Rocket by lining up slots on Rocket/Dish bracket. Slide into place.
Install
F
Waterproof Cables (Qty. 2) to Rocket/Dish
connectors. Rubber boot to be placed over connectors for
weatherproo ng.
3
4
. Attach Stabilizer Bracket to Pole
Select location for Dish antenna and attach the stabilizer bracket to
mounting pole just below where Dish will be installed as shown in gure 4.
Tighten to 14M-m (10 lb-ft). Install
E
Stabilizer Bracket to pole by:
H
M10X100 Bolt (Qty. 2)
O
M10 Washer (Qty. 2)
P
M10 Spring Lock Washer (Qty. 2)
N
M10 Nut (Qty. 2)
4
5. Attach Antenna to Mounting Pole
Mounting bracket can accommodate 1.5"-4"pole.
Mount the antenna slightly above the stabilizer bracket as shown in gure 5
using the following parts:
I
M10X150 Bolt (Qty. 4)
O
M10 Washer (Qty. 4)
P
M10 Spring Lock Washer (Qty. 4)
N
M10 Nut (Qty. 4)
5
6. Adjust Azimuth and Elevation
After a visual alignment of both elevation and azimuth, azimuth can be
adjusted by rotating the antenna while supported by the stabilizer bracket.
Elevation is adjusted by tightening/loosening the elevation rod.
When azimuth/elevation are set tighten nuts to approximately
14N-m(10 lb-ft) or less should the mounting pole show deformation.
Summary of Contents for RocketDish RD-5G30
Page 3: ...6...
