5
4 Cautions for Children
Keep your device out the reach of children in case of accidental injury caused by incorrect use
of the device as toys.
II. Start to Use
1 Battery
The battery which is initially 50% charged can be used immediately. Please fully
charge/discharge the battery for the first three times to get maximum capacity.
1.1 Remove/Insert the Battery
■
Installing the battery
1. of the battery to one end of the sheet metal contact phone battery connector contact
contact;
2. Press down on the battery the lower end;
The phone back cover with the phone body card, battery installation is completed. Make sure
the battery is properly installed before turning.
■
Remove the battery
The battery lower part of the gap at the back cover has been removed, grasped, and pull to
remove the battery.
Note:
(1) Remove the battery before shutdown.
(2) Be sure to operate in accordance with the above method steps.
1.2 Charge the Battery
During charging, the battery indicator on the phone is a thunder icon. If the device is
switched off during the charge, there will still be a charge indication on the screen that shows
the phone is still being charged. If the device is overused when the battery is low, it might take
some time to appear the charging icon.
When the battery indicator on the screen says 'fully charged', then thunder icon will
disappear, which means the completion of charging. If the phone is switched off during
charging, the screen will have a 'fully charged' scene. It generally takes 4 hours to charge the
battery. During charging, the battery, the device and the charger will get hot. This is normal.
Unplug the charger from the AC electrical outlet and disconnect the wiring between
the phone and the charger after charging. .
Attention:
Charge the phone in a well ventilated place in which the temperature is from-10
o
C
to +50
o
C. Use the charger provided by the manufacturer only. The use of unconfirmed
charger may lead to dangers and violate the manufacturer's warranty clause. If the
temperature is too high or too low during the charge, the device will automatically send a
warning and stop charging to avoid damage to the battery or any danger.
2 Connecting to Network
2.1 SIM Card
Insert valid SIM card (subscriber identity module) before using the device.
All information related to the reach of the network are recorded in the chip of SIM card,
including the name, phone number and messages stored in the SIM card contacts. In case of
losing or damaging SIM card information, users should avoid touching the metal touching side
