T
he Strike Finder Touch is our top of the line device and features 5 fully
-
programmable functions designed
to capture images that would
otherwise be humanly impossible to do.
Technical Information:
•
When you first turn on the device, it will “boot
-
up”, indicated by a 1
-
second red flash of the Trigger LED, the screen will launch to the
Ubertronix start page.
•
If the Trigger LED doesn’t flash or the screen does not turn on, please
replace the batteries.
(
The screen may also flash in green words
“Mounting” or “Device not Mounted...”
)
, this also indicates low batteries.
•
Every time the LED blinks, your camera or flash will fire.
•
There are three ports on the side of the device
(
Sound, Motion, and
Camera
)
. The
CAM port
is used to plug in either a sync cable
(
attached
to a flash
)
or a camera cable.
•
The device sits in the hotshoe only for convenience, it is not required to release the shutter.
•
The device uses
4 AAA batteries
and will perform for 3 hours with the screen on and 5 hours with the
screen o
ff
.
•
To turn on the power saving feature, simply tap the
Power Save
button
(
note: all settings are remembered
while in power save mode
)
. To turn the screen back on, tap the screen in the same location as the
Power
Save
button.
•
When plugging in the external sensors, turn the device o
ff
.
•
Please see below for more specific information on each screen.
Copyright 2010-2014 All Rights Reserved. Ubertronix, Inc.
Strike Finder Touch
