Installation and starting the operation
13
Printed: 01/2018 Subject to change!
TopLineUserManual.docx
4 Installation and starting the operation
In general all Rotisseries „Top Line“ will be packed for safe transport after the final
control in order to reach you properly. Nevertheless we ask you to have a look at the
machine on arrival to check on any possible transport damages.
Note!
Visible damages have to be reported immediately!
4.1 Unwrapping
•
Open the carton and take out the wrapping material carefully.
•
Take care that the delivery is complete (see attached freight documents).
4.2 Installation
Place the Rotisserie „Top Line“ at the desired location. Make sure, that it is good
visible for your customer to ensure good food presentation and successful sales.
Take care of the following points:
The TopLine Rotisserie (with or without stand) has to be placed on a horizontal
level. Use a spirit level if necessary.
Note that all ventilating slots have a free space from a wall or similar of at least
10cm (app. 4 inch).
Location underneath a ventilation system is usefull and recomended.
There has to be enough free space to load, unload, clean and maintain the unit.
The machine has to be placed in a way that the complete area around it can be
cleaned easily.
4.3 Electrical connection
Note!
In general, only service technicians of the company: UBERT GASTRO-
TECHNIK GMBH or service technicians of your responsible service partner are
allowed to perform el. connection and other service! All national and local rules and
regulations concerning electricity, fireprotection and similar have to be considered.
During any servicing, take care that the unit is disconnected from the mains! Not
paying attention may result in injury!
Please learn the electrical and technical data of your unit from the name plate.
Check whether your local electrical power supply is in accordance with the values on the name
plate.
The power supply needs to be manufactured from heat resistant, flexible cable. It is to be routed
to prevent any contact to hot parts.
The unit is to be connected to the power supply either by means of an appropriate plug or if
connected permanently, a switch (interrupting all poles) is to be provided. In case of an
emergency the power supply must be interruptable immediately.
For further information please see the wiring diagram (attached).
Note!
After finishing any installation work, maintainance or repairs check whether the
ground wires are connected properly to the casing.
Summary of Contents for RT 403
Page 1: ...User Manual Rotisseries Top Line RT Series...
Page 2: ......
