Uberhaus 87795012, Operator'S Manual

Page: 11 / 30

INSTALLATION INSTRUCTIONS
Electrical Shock and Personal Injury Hazard
in windows made differently than those shown in these instructions.
A high widow accessory kit is available for window heights up to 62 (1575mm).
,,
Meeting Electrical Requirements
WARNING
!
Electrical ground is required on this appliance.
non-metallic gaskets, or other insulating
perly grounded.
installed by a qualified electrician.
grounding circuit. A fuse in the neutral, or
shock.
DO NOT use an extension cord with this
appliance.
in electrical shock, serious injury, or death.
Observe all local governing codes
and ordinances.
Do not, under any circumstances,
remove the power supply cord
grounding prong.
NOTE: If codes permit, and a separate grounding
wire is used; it is recommended that a qualified
electrican determine that the grounding path is
adequate and not interrupted by plastic, non-
metallic gaskets, or other insulating materials.
Receptacle wiring
Receptacle wiring should be a minimum of 14
gauge. Use copper wire only. It is your responsibility
to provide proper and adequate receptacle wiring,
installed by a qualified electrician.
Electrical requirements
A time delay fuse or time delay circuit breaker is
also required. A separate circuit, serving only this
appliance, MUST be provided.
Preparing for Installation
Installation Tips
For wood-frame casement windows: It may be necessary to construct a frame, using at least
1-inch thick wood, with a 15-1/2-inch wide opening.
For brick or cement building construction: It may be necessary to put a wood stool strip under
AC, for mounting purposes.
Flat-head screwdriver
Phillips-head screwdriver
Carpenter s level
Tape measure
Fine tooth saw
Electric or hand drill
`
10
NOTE: These instructions describe installation in a typical wood framed window with a wood sliding
DO NOT ground to a gas line.
If cold water pipe is interrupted by plastic,
materials, DO NOT use for grounding.
in doubt as to whether the appliance is pro-
DO NOT modify power supply cord plug. If it
DO NOT have a fuse in the neutral or
grounding circuit could result in an electrical
Failure to follow these instructions could result
Check with a qualified electrician if you are
does not fit in the outlet, have a proper outlet
Tools required(not included):
sash, or installation in a metal casement window. Modification may be necessary when installing