13
D
E4
H
W1
D
B
D
E3
H
W1
D
B
D
W1
D
C
C
B
C D
D
D
D
C
C
B
C D
D
D
W1
7. Attach the Top Supporting Tube. See Fig.7.
7.1. Attach Long Top Bar (C) to Lower Central Connector (B) with Bolt (W1).
7.2. Attach the other Long Top Bar (C) to Lower Central Connector (B) with Bolt (W1).
7.3. Attach Top Connector (K) located below Long Top Bar (C) to Post (J) with Bolt
(W1).
7.4. At this point, the assembly should look like Fig 7.4.
7.5. Attach third Long Top Bar (C) to Lower Central Connector (B) with Bolt (W1)
7.6. Attach Top Connector (K) which is below Long Top Bar (C) to Post (J) with Bolt
(W1).
7.7. At this point, the assembly should look like Fig 7.7.
7.8 - 7.10. Attach the fourth Long Top Bar (C): repeat the above steps. After all long
bars are attached the assembly should look like Fig 7.10.
7.11. Attach Short Top Bar (D) to Lower Central Connector (B) with Bolt (W1).
7.12. Attach the underside of Short Top Bar (D) to Connection Piece (H) with Bolt
(W1).
7.13. At this point, the assembly should look like Fig 7.13.
7.14. Attach Short Top Bar (D) to Lower Central Connector (B) with Bolt (W1).
7.15. Attach the underside of Short Top Bar (D) to Connection Piece (H) with Bolt
(W1).
7.16. At this point, the assembly should look like Fig 7.16.
7.17 - 7.28. Attach the remaining four Short Top Bars (D), using the same method as
stated above. After all bars are attached, the assembly should look like Fig 7.28.
Adjust the position and alignment of all ten bars (ensuring they are vertical and parallel).
At the same time, adjust the Connection Piece (H). Ensure all ten bars are installed
correctly.
