background image

Ubee Interactive — www.ubeeinteractive.com 

 

 

 

  Ubee DVW326B – Safety and Installation Product Insert 

FCC Caution: Any changes or modifications not 
expressly  approved  by  the  party  responsible  for 
compliance  could  void  the  user's  authority  to 
operate this device. 

IEEE 802.11b,g,n operation of this device in the 
U.S.A. is firmware-limited to channels 1 through 
11. 

FCC Radiation Exposure Statement: 

This  device  complies  with  FCC  radiation 
exposure  limits  set  forth  for  an  uncontrolled 
environment. This device should be installed and 
operated  at  a  minimum  distance  of  20cm 
between itself and your body. 

This device must not be co-located or operating 
in  conjunction  with  any  other  antenna  or 
transmitter. 

Safety Notices   

Read  these  instructions  carefully  before 
operating the device. It is important to be aware 
of  these  safety  instructions.  Install  the  device 
according  to  these  instructions  and  keep  this 
guide for future reference. 

1.  Do  not  use  this  device  in  a  humid  space,  in 

the rain, or near splashing water. 

2.  Do  not  install  during  thunder  or  lightning 

storms. 

3.  Do not cover any ventilation openings in the 

device case. 

4.  Do  not  place  the  device  near  heat  sources 

such as radiators or stoves. 

5.  Clean the device only with a clean, dry cloth. 

Do not use liquid or chemical cleaners. 

6.  Avoid  static  discharge  when  touching  the 

device by first touching the coaxial connector 
of the coaxial cable. 

Summary of Contents for DVW326B








Reviews: