UAV-1006666-001
11
Rev A
6.3.2 Configuring the AV-30-C to Communicate with the tailBeaconX
After serial port wiring is complete, the AV-30-C must be configured to
communicate with the tailBeaconX. This can be accomplished with the
steps below.
1. To access the AV-30-
C “Install” menu, see AV-30-C Installation
Manual UAV-1003947-001 Section 14.
2. AV-30-C must be configured for tailBeaconX control. From the AV-
30-
C “Install” menu, configure “SERIAL 2” to “BEACON X” as shown
below.
6.4 Accessing the AV-30-C Transponder Control Fields
The transponder control fields, such as, Transponder Mode Selection
(STBY, ON, ALT), Ident, and Mode A (squawk code) overlays on top of the
reversionary AI display when properly configured. The reversionary AI
display is accessible by AV-30-Cs configured as either an AI
or
DG.
To access the reversionary AI page from either the AI or DG main page,
press the bottom right
“HLD/BRT” button several times until the fields as
shown in the Appendix A figure are visible. If these fields are not visible,
then the AV-30-C is not configured properly. See section 6.3.2 above.
7 Installation
Installation of tailBeaconX is a two-part install. It requires installation of a
tailBeaconX and an AV-30-C (if not already installed).
