UAV-1004270-001
25
Rev A
5. Temporarily align the Mounting Plate to the opening, and ensure the
depth of the cavity is sufficient to fully contain the tailBeaconX body. If
not, follow the Spacer Mounting installation procedure in Section
7.5.2.
6. Install the Mounting Plate, in the appropriate orientation for your
aircraft, using either the supplied #4 or #6 hardware, or as defined
below.
a. If the included hardware does not match the thread type of your
aircraft, it is acceptable to use standard aviation hardware
compatible with the thread types required, only if when
installed, the screw heads do not protrude from the surface of
the mounting plate as shown below.
Note: Installation of the tailBeaconX must be in accordance with AC 43.13-
2B, Chapter 1.
7.5.2 Spacer Mounting
Aircraft with an installation cavity shallower than required to mount using
the Direct Mounting method, or with other mounting interference issues,
may use the spacer included with Installation Kit UAV-1003793-001.
Follow instructions in Section 7.5.1, but additionally install the optional
spacer between the aircraft surface and Mounting Gasket. Ensure proper
engagement of the mounting hardware, considering the additional spacer
thickness.
