skySensor
____________________________________________________________________________________
________________________________________________________________________________
uAvionix reserves the right to alter product, services offerings, specifications, and pricing at any time without notice
© Copyright 2017 uAvionix, All rights reserved.
www.uavionix.com
UAV-1001479-001
Installation Procedures
skySensor is a wingtip, forward, right position light. The assembly should be mounted
as far outboard on the aircraft as practical, parallel to the vertical and horizontal
centerlines of the aircraft. Ensure that when mounted, the fin and top of the assembly
are free from obstructions.
1. Remove the existing right position light.
2. Detach the power wire(s).
3. Connect the red wire to the switched power wire.
4. skySensor is grounded to the aircraft structure via the mounting screws.
However, it may be necessary to connect the black wire to the airframe ground.
5. Mount skySensor using the three supplied 6-32 screws and o-rings.
See diagram page 3
Changes to the existing position light circuit breaker rating are not required.
Connecting an Electronic Flight Bag
1. Apply power to skySensor by turning the position lights on.
2. Connect your wireless device to the skySensor SSID.
3. Once connected follow the instructions for your electronic flight bag application.
4. Traffic, weather and GPS data will be available to the application.
Applications supporting GDL90
Wiring Considerations
Connect the red wire to the switched power wire.
Connecting the black wire to the aircraft structure should be suitable but
it may be necessary to connect the black wire to the battery ground in
some cases.
Connect the yellow wire to the strobe switch. The strobe high voltage
power supply must be bypassed for the skyBeacon. Connecting
skyBeacon to the HV strobe power supply will damage the device.
