ADSL Router AR-1150 User Manual
7
Hardware Installation – Single PC Connection
Before configuring your ADSL router, you must complete the hardware installation using
the following steps.
1. Be sure the power switch, marked
O N / O F F
, on the rear of the unit is depressed, in
the OFF position.
2. Connect the power adaptor to power receptacle on the rear of the unit marked
P W R
,
then plug the AC end into the wall electrical outlet.
3. You will now connect the Ethernet cable. Connect one end of the Ethernet straight
connect cable to the Ethernet jack on the NIC in the back of your PC.
4. Then connect the cable to the rear marked
Ethernet
on the back of the router.
5. Connect one end of RJ- 11 ADSL cable to the ADSL line jack, marked
Line
,
on the
rear of the router. Then connect the other end to the ADSL line outlet that your
ADSL service provider has installed.
6. Connect the male (9- pin) end of the RS- 232 serial cable to the connector marked
RS-232
on the rear of the router.
7. Then plug the other end of RS-232 cable into the serial port of your computer.
8. Turn the power on by pressing the power switch. The router will perform a self-test
then will be ready for use.
