U-SLENDER FAT BREAKER, User Manual

Page: 2 / 5

FAT BREAKER TM
1 | P a g e
Fat Breaker Instruction Manual
Stubborn fat cells are high in alpha receptors, which prevents them from releasing their fat content regardless of
sport and diet. The Fat Breaker works by assisting in dismantling subcutaneous fat using controlled heat. A micro
current is delivered through the skin, heating fatty tissues to the point where fat cells begin to break down. The
Fat Breaker heats up and gradually targets fat cells. The energy also helps to stimulate collagen by penetrating
deep into the skin tissue.
Fat Breaker Instructions
Congratulations on your purchase of the Fat Breaker! The Fat Breaker device is used to massage and help break
up cellulite and fat deposits. Use the Fat Breaker device on dry skin to help soften body fat and increase circulation
on the arms, legs, thighs, hip, waist, and belly with micro heating massage therapy. For best results, it is suggested
to use the Fat Breaker device twice daily for a minimum of 20 minutes per session.
How to Use
Step 1. Before use, remove the Fat Breaker device from
the protective case and make sure the device is fully
charged using the USB charging cable provided.
Step 2. Press and hold the Start button for 2 to 3
seconds to turn on the device. The blue light indicates
that the device is on.
Step 3. If heat therapy is desired to promote local
circulation, first turn on the device, then press the
button marked “M.” The red light on the “M” button
indicates the device is heating up. Note that to get
complete heat will take 4 to 5 minutes. Preheat the Fat
Breaker device for 4 to 5 minutes before beginning a
heat therapy massage session.
Step 4. Note the color settings. The green setting promotes double absorption effect. The yellow setting promotes
sub dermal stimulation and firming. The red light indicates heat compression therapy. The blue light indicates the
device is turned on and provides a neutral soothing effect.
Step 5. Place the device on the target area of skin and apply gentle pressure, slowly and steadily scraping the device
from top to bottom across the entire area of the body. Repeat the scraping motion from top to bottom. The
recommended duration of a session is 20 minutes.
Step 6. Place the device on the target area and apply gentle pressure. Slowly and steadily begin to scrape the device
across the entire length of the target area, creating a back and forth pattern until contact has been made with the
entire area.
Step 7. If the device gets uncomfortably hot, press the button marked “M” to turn off the heat function.
Step 8. To turn off the Fat Breaker device, press and hold the start button for 2 to 3 seconds until the blue light
disappears.