1. To prevent electrical shock, disconnect transformer from electrical supply before installation or service.
2. Using the wiring compartment J-Box as a template, mark mounting hole position.
3. Strip the wire leads from the main supply cable. Connect main supply cable to luminaire
leads using silicone filled safety connectors (provided).
NOTE:
Connections may be made remotely or inside J-Box wiring compartment.
4. Use appropriate screws (by others) to fasten to mounting surface.
NOTE:
Luminaires are supplied with 60" of 18-2 cable pigtail for secure connection to the main
supply cable. The wire is to be protected by routing in close proximity to the luminaire.
The wiring shall be buried a maximum of 6 inches (15.2 cm) in order to connect to the
main supply cable.
5. Provide power to luminaire and check for proper operation.
IMPORTANT SAFETY INSTRUCTIONS
LIGHTED LAMP IS HOT!!
WARNING: TO REDUCE THE RISK OF FIRE, OR INJURY TO
PERSONS:
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamps get hot quickly! Contact only switch/plug when turning on.
3. Do not touch hot lens, guard or enclosure.
4. Keep lamp away from material that may burn.
5. Do not operate luminaire fitting with a missing or damaged cover.
LAMP INSTALLATION/REPLACEMENT:
CAUTION: Do not exceed maximum wattage marked on luminaire label.
1. To prevent electrical shock, disconnect transformer from electrical supply before service.
2. Loosen screw from shroud.
NOTE:
Long shroud uses a phillips head screw to fasten shroud. Short shroud uses an
allen screw (allen wrench provided). Please save allen wrench for future use.
3. Remove shroud to expose lamp.
4. Replace lamp with correct wattage and type marked on fixture label.
5. Re-install shroud and tighten screw.
VISTA PROFESSIONAL OUTDOOR LIGHTING Division of U.S.T.E. Inc. Website: www.vistapro.com
1625 Surveyor Avenue, Simi Valley, CA 93063 (805) 527-0987 FAX: (805) 527-6830 (800) 766-8478
