background image

Installation and Mounting Guide

Radiant Flexible Tube Kit

TOOLS REQUIRED

•   Ladder
•   Reciprocating saw or jig saw 
•   Power drill with a 1/2” – 1” inch drill bit 

     (only one needed) 

•   1 – 2” deck screw and screw bit
•   Hammer & roofing nails or self tapping 
     galvanized screws (included)
•   Tin snips or wire cutters

•   ASTM D 4586 Type 1 Asphalt Roofing Cement 
•   Measuring tape or ruler
•   Pencil or chalk
•   Roofing knife or box cutter
•   Flat pry bar
•   Sheetrock saw
•   Adjustable Wrench or Pliers
•   Phillips Screwdriver or Drill Bit

Thank you for purchasing a SkylightTube from U.S. Sunlight Corp.  We are committed to providing alternative energy products 

that can improve your everyday life and our environment. 

If there is a problem with your U.S. Sunlight product call us at 1-877-50-USSUN

Spare parts, installation advice, or recommendations for professional installers in your area are only a phone call away.  

Professional installation may be much less than you expect, please call us to get average rates for your area. 
Please note that this product is designed for asphalt shingles.  If you have spanish tile, s-tile, concrete, metal or flat roof, 

please call us before attempting to install the product. 
Before beginning the installation of your new SkylightTube, please read through the entire installation 

instructions and call us if you have any questions.

When deciding on a location for the Radiant SkylightTube, it is important to: 

a.   Make sure you are locating the final position centered between two ceiling joists. If your     

      ceiling joist spacing is less than the recommended spacing, refer to your local building  

      code prior to cutting a rafter or ceiling joist.

b.   Before beginning the installation, make sure there are no obstructions in the attic space  

      and on the roof where you would like to install the the Skylight Tube.

c.   Confirm the greatest distance between the ceiling hole location and the roof dome location  

      is no more than 5½  ft. If the distance is greater than 5½ ft., contact U.S. Sunlight directly at   

      1-877-50-USSUN. 

Tel: 877-50-USSUN

© Copyright 2013 US Sunlight Corp, Inc. Radiant Skylight Tube C01 ver 1

www.ussunlight.com

[email protected]

ATTENTION: 

Please consult a professional installer if you are unsure of where to locate your Skylight Tube or if 

you do not feel comfortable with the installation process.

TM

Summary of Contents for Radiant Skylight Tube







Reviews: