SKU 94122
For technical questions, please call 1-800-444-3353.
Page 5
OPERATION
WARNING! Make sure the vehicle is properly and securely raised on the lift before
raising the Oil Drain into place. Follow all safety precautions outlined in this
manual and the vehicle’s manual.
1.
To operate the Oil Drain, slightly unscrew the Adjustable Clamp (5) and allow the
two tubes and the Funnel (2) to slide downward to the lowest position.
2.
Move the 18 Gallon Oil Drain under the raised vehicle, making sure the Funnel (2)
is positioned directly below the oil drain plug of the engine.
3.
Raise the Upper Tube (3) and Funnel (2) until the Funnel (2) sits approximately 4”
directly below the oil drain plug of the engine. Then, tighten the Adjustable Clamp
(5) to hold the Upper Tube, Lower Tube and the Funnel in place.
4.
Remove the oil drain plug of the engine, and allow the old oil to completely drain
from the engine into the Funnel (2) of the 18 Gallon Oil Drain.
(See Assembly. Diagram. Page 8)
5.
Once the old engine oil is completely drained, replace the oil drain plug of the
engine and refill, if needed.
6.
When emptying the old oil from the Tank (6) of the Oil Drain, make sure to follow
guidelines for engine oil disposal.
If necessary, contact your local solid/liquid waste
authority for information on recycling and/or disposal.
ASSEMBLY
NOTE:
Please refer to the Assembly Diagram on page 8 for the following assembly
instructions.
1.
Insert Funnel (2) into the Upper Tube (3) and secure it using two Screws (1).
2.
Connect the Upper Tube (3) to the Lower Tube (4). Secure it using a Bolt (9), a
Washer (10), and a Nut (11).
3.
Put the Lower Tube (4) into the Tank (6). Tighten the Adjusting Clamp (5), securing
the Lower Tube (4) in place.
