Page 3
For technical questions, please call 1-888-866-5797.
Item 58956
3. Connect Bar (4), pre-assembled with
10x Brackets, to Left and Right Panels
using four Self Taping Screws (8).
Bar
(4)
Self Tapping Screw (8)
4. Determine the height of each Cup, then attach the
3x Large Cups (5) and 2x Small Cups (6) to the
Back Panel with five Self Tapping Screws (8),
one per Cup.
a. Place largest power tool (sold separately)
in a large cup. Hold tool in cup and place
its handle horizontally on the bar. Handle
should rest level on the bar and tool
should be fully inside the holster.
Note:
If tool not fully inside the holster, lower the bar.
b. Secure cup to Back Panel using
the supplied screw.
c. Repeat for all remaining cups. Fit the
tool (sold separately) in the cup, rest tool
handle on the bar then secure the cup to
the Back Panel using a supplied screw.
d. Arrange cups so that three large cups
are on one side and two small cups are
on the other side, as shown below.
Note:
Cups will likely be at different heights.
Large Cup (5)
Self Tapping Screw (8)
Small Cup (6)
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
1. The Holder is compatible with US General
Series 3 Cabinets 56" and 72".
2. Pull out a bottom drawer and place empty,
assembled Tool Holster inside.
3. Load tools (sold separately), making sure they
fit fully inside the holster and are secure. Be
sure drawer fully closes with all tools loaded.
Parts List and Diagram
Part
Description
Qty
1
Back Panel
1
2
Left Panel
1
3
Right Panel
1
4
Bar
1
5
Large Cup
3
6
Small Cup
2
7
Bracket
10
8
Self Tapping Screw
13*
Notes:
*
only one Screw shown.
1
2
3
4
5
6
7
8
