19
111679-02 - 1/23
Appendix (continued)
Specifications
Power
24VDC via DC Barrel Jack:
-Power supply: AC 100-240V, 50/60Hz input,
DC 24V 0.3A output
24VDC via RJ12:
-Power supply: DC 24V 0.04A input
24VAC via RJ45:
-Power supply: AC TBD input
Environmental and Regulatory:
-
Certifications: FCC, UL508, UL840* (TBD)
-
Environmental protection: IP10 (Nema 1)
-
Flammability: UL94-V0
-
Working humidity range: 0-95% (non-
condensing)
-
Working temperature range: -50oF - 104oF
(10oC to 40oC)
Repair Parts
1.
USB-Connect Bluetooth Adaptor Kit---------------------------------------------------US Boiler P/N: 111667-01
US-Connect Bluetooth Adaptor (Portable Tool, Connects USB-Connect App and Portal to: Alpine, Alta,
AltaC, Aspen, AspenC, K2WT, K2WTC, K2FT, XC.); Carry case, information card; CST Sage Controller J3
Terminals to RJ45 Interface Board (111640-01); Cable 1, RJ12 Straight Cable; Cable 2, RJ45 Split Cable;
Cable 3, RJ45 Straight Cable.
2.
Connected Service Tool Sage J3 Terminals to RJ45 Interface Board--------US Boiler P/N: 111640-01
Connected Service Tool Interface Board, used to connect Sage Controller J3 screw terminals to Bluetooth
Adaptor or Remote Monitoring System using an ethernet cable.
3.
Cable 1, RJ12 Straight Cable-----------------------------------------------------------Show Me Cables P/N: 15-302-003S
Standard RJ12 Line Cord, 24AWG, stranded copper conductors, 6 conductors, straight through, PVC jacket,
Silver, Standard Boot, 36-inch length.
4.
Cable 2, RJ45 Split Cable----------------------------------------------------------------US Boiler P/N: 111662-01
Custom cable has two RJ45 connections on one end and single RJ45 on opposite end. Used to connect
Bluetooth Adaptor to Sage equipped boiler’s Boiler to Boiler and Enviracom RJ45 connections, Black,
Standard Boots, 24-inch length.
5.
Cable 3, RJ45 Straight Cable------------------------------------------------------------Show Me Cables P/N: 530-03 BL
Standard Cat5e Ethernet Patch Cable, 24AWG, stranded copper conductors, 8 conductors, straight
through, PVC jacket, Blue, Standard Boot, 36-inch length.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
