U-Reach PRO368, User Manual

Page: 7 / 28

Chapter
➀
- Product Introduction
7
3
Function Table
Function Description
1. Copy
To copy source HDD to multiple target HDDs. Refer to function [6.1 Copy Area] for 4 different
copy modes selection.
2. Compare
To compare data bit for bit between source and target HDDs.
3.Copy +Compare
It makes copy first and then compare target HDD with source HDD to ensure data
correctness.
4. Erase
4.1 Quick Erase
To erase HDD’s index table only, it takes short time to execute this function.
4.2 Full Erase
To erase the whole HDD content.
4.3 DoD Erase
To erase HDDs three times complying with USA Department of Defense (DoD) standard.
It takes 3 times longer than full erase.
4.4 DoD EraseComp
To erase HDDs three times complying with USA Department of Defense (DoD) standard and
bit by bit to check if data is completely erased.
It takes 4 times longer than full erase.
4.5 Secure Erase
The international authorized high standard Secure Erase function. It is able to erase the area
which is not loadable.
5. Utility 5.1 Show Disk Info.
5.1.1 Model Number
To show HDD's model number.
5.1.2 Version of Firmware
To show HDD's firmware version.
5.1.3 Serial Number
To show the serial number of HDD.
5.1.4 Device Power Cycle
To show the count of HDD's turning on and off.
5.1.5 Power-on Hours
To show the total hours of HDD power-on.
5.1.6 Reallocation Event Count
It represents the count of failing to save data.
5.1.7 Off-Line Scan Uncorrectable Sector Count
To show the sector volume that is uncorrectable when scanned
off-line. The more the uncorrectable sector volume is, the more
serious the HDD's damage is.
5.1.8 Seek Error Rate
To show the error rate of searching for data. It can represent the
damage rate of data stored in the HDD.
5.1.9 Temperature
To show the temperature of HDD.