U-Prox Keypad MF, User Manual

Page: 3 / 4

Integrated Technical Vision Ltd.
http://www.itvsystems.com.ua
3
Data transfer and control of annunciation
The reader is provided with two-colour LED indicators and buzzer. LED and buzzer function
according to interface type programmed and annunciation mode.
Wiegand Interface
Engaging of LED and buzzer is possible automatically or by grounding of corresponding
wire according to Table 2.
Keypad codes
Reader transmits keypad codes in one of the programmed modes
– package or digit-by-
digit.
In package mode reader stores up to 10 presses of ‘0’ to ‘9’ keys and transmits package
after the ‘#’ key press. If there are less than 10 digits pressed the leading digits filled with
hexadecimal digit ‘F’. The ‘*’ key press clears all previous key presses.
In digit-by-digit operation mode reader transmits the key code immediately after the key
press with 6-bit package. The key codes are in the table below:
Key
Code transmitted
key
Code transmitted
(hex) (binary) (hex) (binary)
0 01 000001 6 2C 101100
1 02 000010 7 2F 101111
2 04 000100 8 31 110001
3 07 000111 9 32 110010
4 29 101001 * 34 110100
5 2A 101010 # 37 110111
DORADO digit-by-digit operation. In this mode reader transmits the key code immediately
after the key press with 8-bit package. The key codes are in the table below:
Key
Code transmitted
Key
Code transmitted
(hex) (binary) (hex) (binary)
0 F0 11110000 6 96 10010110
1 E1 11100001 7 87 10000111
2 D2 11010010 8 78 01111000
3 C3 11000011 9 69 01101001
4 B4 10110100 * 5A 01011010
5 A5 10100101 # 4B 01001011
Table 2. Annunciation mode:
Data transmissions from reader comply with standard Wiegand26, Wiegand32, Wiegand34,
Wiegand37, Wiegand40, and Wiegand42.
Buzzer Red LED Green LED
00 Beep on card read LED normally on, switch off at reading Blinking at reading
01 Control from outside LED normally on, switch off at reading Blinking at reading
02 Beep on card read Switch off Blinking at reading
03 Control from outside Switch off Blinking at reading
04 Beep on card read LED normally on, switch off at reading Control from host
05 Control from outside LED normally on, switch off at reading Control from host
06 Beep on card read Control from host Control from host
07 Control from outside Control from host Control from host
08 Beep on card read
Possibly to control
from outside LED normally on, switch off at reading
Possibly to switch off from outside Blinking at reading Possibly to
switch on from outside
Data transfer depends on interface type. For TouchMemory interface it is identifier Type 01
according to DS1990.
Depending on length of Wiegand interface used, data transmitted for MIFARE
®
Classic 1K,
may vary as shown in table below for card ID B8 26 E0 FC
.
The first byte in this ID is XOR
of all bytes of ID:
Direct order Reverse order Parity bits
W26 0-26E0FC-1 1-FCE026-0 +
W32 B826E0FC FCE026B8 -