11
Opening door with RF ID
To open the door user passes RF ID to the reader. If RF ID is enrolled and the
passage is granted, access point opens and
panel will send “Access granted” event
to the access control system. The reader LED becomes green.
Exit from premises
To exit from premises press inner door handle. Pressing the handle opens the door
mechanically. If RTE microswitch installed panel will send
“Request-to-exit” event to
the access control system.
Access denial upon entering RF ID
Access may be denied to RF ID owner due to the following reasons (the reader LED
is red):
Cards (RF IDs) and schedules are not loaded in the panel (light off)
access control panel is in unloaded state
card is not enrolled in the panel
card term expired
RF ID passed is out of schedule
RF ID passed is marked as lost or blocked
the panel is in "Alarm" mode
the panel is in "Blocked" mode
pass count is exhausted for the temporary card (visitor).
“Alarm” Mode
Depending on the programmed functions Access point goes into mode
"Alarm"
in
case of unauthorized passage (Door Forced Open), opening of panel cover, entering
RF ID recorded as lost, if AP is open too long (open time AP is exceeded), in case of
RF ID matching attempt, opening the door with the key or the cylinder handle.
If Access point
is in “Alarm mode", passage is
forbidden
. Access point may be
opened with inner door handle .
To exit from the "Alarm" mode pass the ID with "Alarm Cancel" attribute or by
command from the computer.
"Free Pass” Mode
There are circumstances when you need to open access points for Free pass of
people, such as in the case of fire, earthquake or in other emergency. For this case,
the panel has "Free Pass" mode.
In "Free Pass” Mode LED of reader flashes green and yellow on any (even not
enrolled) ID passed.
The access point goes into "Free Pass" mode after the command of operator from
the computer The access point is in "Free Pass" mode until the command from the
computer comes (command from the computer will not work).
