11
Folding, Moving and Unfolding Instruction:
1)
Folding: The treadmill is foldaway. Lift the end of the main frame and fold upwards until the
connecting bar rebound to the cover of cylinder tube. (See figure a)
2)
Moving: Press the handrails to make the front base foot away from the ground then push the
treadmill after folding.
3)
When you want to put the treadmill to the work position, please lift the end of main fame
(end cap) a little to make the foldaway support tube higher than the cylinder cover (see figure a-1),
tip the foldaway support tube with your foot slightly (see figure a-2), press the end of main fame
(end cap) forcibly, remove your foot and keep on pressing the end of main fame for a while.
The cylinder will shrink under the weight of itself (see figure b) and the main fame goes flat.
Maintenance and Malfunction Treatment:
1)
The surface of the treadmill should be kept clean, pull out the power line before cleaning.
You can clean the running belt and the surface of the treadmill with a soft and wet cloth.
2)
The running belt is adjusted at factory; it may runs defectively after transportation and use.
Turn off the treadmill before adjusting, pull the belt in the center, and then adjust the left and
right bolts in rear roller with hex spanner (See figure ) it is better to adjust 1/2 circle once.
Then turn on the switch, check if the belt 10 runs defectively when the running speed is 4~5 km/h.
3)
After using over 100hours or the
lubricant between the running board
and the running belt is used up, please
lubricate the running board and adjust
the running belt well.
4)
After a long time of running, the belt
may be longer and stuck. You should
turn the left and right adjustor bolt in
rear roller clockwise at same position
till the runs smoothly and freely.
