PAGE 3 OF 8
0719 IH-8098
TOOL HOLDER
1. Set tank cover onto the tank. Position with back of
tank cover facing you.
2. Press tabs of tool holder into the slots on mounting
lugs, located on back of tank cover. (See Figure 2)
3. Press down until tabs snap into place. Remove
tank cover from tank and refer to the set up and
operation section. (See Figure 3)
WARNING! This equipment has parts including
switches, motors and the like that tend to
produce arcs or sparks that can cause
an explosion. Do not pick up flammable,
combustible or hot materials. Do not use
around explosive liquids or vapors, as electrical
devices produce arcs or sparks, which can
cause a fire or explosion. Do not use at filling
stations or anywhere gasoline is stored or
dispensed.
1. Refer to the filter installation and maintenance
section to make sure the correct filters are installed
for your cleaning operation.
2. Replace tank cover. Make sure each latch or clamp
is secured over raised area of the tank cover. Failure
to properly secure latches could cause tank cover
to release from tank.
3. Insert machine hose
end with locking nut
into inlet in front of the
tank. Turn locking nut
clockwise to tighten.
Do not over-tighten.
(See Figure 4)
4. Attach desired
cleaning accessory
onto accessory end
of hose.
5. Plug cord into wall outlet. Your cleaner is
ready for use.
1. Remove vacuum cleaner and all accessories from
the carton.
2. IMPORTANT: Open tank cover by pushing latches
or clamps outward with thumbs and remove any
accessories that may have been shipped in tank.
3. Depending on dry pick-up or wet pick-up operation,
install proper filter. (See page 7 for filter guide)
4. Replace cover and make sure latches or clamps
are secured over raised area of tank cover.
UNPACKING
ASSEMBLY
SET UP
Figure 2
Figure 3
Figure 4
