PAGE 3 OF 9
0415 IH-2665
STORE HOSE AND ACCESSORIES
1. The crevice wand (6) stores inside the larger wand (7) on
the back of the vacuum. The dusting brush (8) stores in
the dusting brush holder (9) on the back of the vacuum.
(See Figure 3)
STORE ELECTRICAL CORD
1. The cord retainer (10) can be found on the handle
above the upper cord hook (11). Firmly push the
electrical cord down into the cord retainer. This will
place the cord out of the way the next time you
vacuum. (See Figure 4)
2. Next wind the cord around the two cord hooks (11) on
the back side of cleaner. (See Figure 4)
3. Secure the plug (12) to the cord to prevent unwinding.
(See Figure 4)
USE AND MAINTENANCE
1. Step on handle release (1) to pull handle back to
a comfortable operating position. To lower handle
completely to the floor, depress handle release a
second time. (See Figure 5)
2. Cleaner height setting (2) is an adjustment that raises
or lowers the cleaner base to match the type of floor
surface. With the cleaner cord unplugged, set the
adjustment to highest setting. (See Figure 5)
3. Turn machine on and lower handle to operating
position. Then lower height setting one notch at a time
until you hear brushes touching floor. This should be
a noticeable sound change. If the cleaner is difficult
to push, move adjustment to next highest setting until
cleaner is comfortable to push. For ease in moving the
adjustment knob, place handle in operating position
and tilt cleaner back to remove weight from front wheels.
(See Figure 6)
NOTE: The brush roll must reach carpet for
effective cleaning.
NOTE: Setting vacuum height too low could cause
premature wear on belts, brushes and motor.
ASSEMBLY CONTINUED
12
11
11
10
6
7
8
9
1
2
Figure 3
Figure 4
Figure 5
Figure 6
Store
Operate
Clean Under
HELPFUL INFORMATION:
Before cleaning under
low furniture, check
area first for objects that
might harm the unit or
block the vacuum hose.
