PAGE 3 OF 6
1018 IH-7357
STORAGE
CHARGING INSTRUCTIONS
OPERATION
• Charge battery every three to six months in storage
to keep the internal battery fully charged to prolong
the overall battery life.
• Avoid storing in direct sunlight, in extreme heat or
cold, and wet or damp areas.
• It is recommended to keep this unit indoors when
outside temperature is below 32°F.
• Always store battery clamps attached to the posts
on the unit and accessories properly within the jump
starter.
IMPORTANT! Charge immediately after
purchase, after each use and every three
to six months. Only use the charging cables
provided with the unit.
• Keeping the internal battery fully charged will help
to prolong the overall battery life.
• Always disconnect and store charging accessories
properly within the jump starter case.
• AC charging cable and DC charging cable are
included with unit.
• AC charging cable: Connect the AC plug to the
unit, then connect the charger to a grounded AC
electrical outlet. The charger is now activated.
• DC charging cable: Connect the DC plug to the
unit, then plug the 12 volt adapter into the DC
socket or the car. The charger is now activated.
TURNING JUMP STARTER ON/OFF
• Press the power button for three seconds to switch
on the device.
• Press the power button for three seconds to switch
off the device.
USING LED LIGHT
• Activate power button on the jump starter.
• The light works in the following sequence by pressing
the switch:
• Press light button once – flashing white light.
• Press light button twice – steady white light.
• Press light button third time – turns off light.
USING USB PORTS
• The two USB ports provide up to 2.4A at 5V DC.
• Activate power button on the jump starter power
pack.
• Plug USB device into the connector port of the unit.
TEST – VEHICLE BATTERY
• Make sure the vehicle ignition is turned off, and that
the engine is not running.
• Connect clamps to red positive (+) clamp to the
positive (+) post of battery, then connect the black
negative (–) clamp to the negative (–) post of battery.
• Activate power button on the jump starter.
• Press the test button once to choose battery test
function (
); LCD will display vehicle battery voltage
and its status (low, mid or full).
TEST – VEHICLE ALTERNATOR
NOTE: The vehicle's engine will need to be
running for this test.
• Connect the jumpstart red positive (+) clamp to
the positive (+) post of battery, then connect the
jumpstart black negative (–) clamp to the negative (–)
post of battery.
• Activate power button on the jump starter.
• Press the test button twice to choose alternator test
function ( ); LCD will display vehicle alternator
output voltage and its status (low or full).
